Replacing a Leaking Plug Cylinder Head on a Honda Jazz GD1
To remove the plug you’ll need to pry it off little by little on all sides using a small flat screwdriver. Chances are the plastic is brittle and when you try to pry it on one side one of the tabs might break off and will fall inside which is bad.
Clean the dried oil on the surface of the hole, use a scrub pad if necessary.
Install the new plug into the cylinder head. And thats it you’re done.
No comment
Say something
Thank you
Your post has been submitted and will be published once it has been approved.
OK
OOPS!
Your post has not been submitted. Please return to the page and try again. Thank You!
If this error persists, please open an issue by clicking here.
OK